Fagor alarm 6034: Reset in CAN node
CNC 8060/8065/8070 CNC error · Fagor 8060/8065/8070
What it means
A remote CAN node rebooted during operation; the error window shows which node number. Momentary resets come from supply glitches or watchdog trips inside the node. If the same node recurs, verify its 24 V feed and ribbon connections, then plan replacement of the module.
Likely causes
- unstable 24 V node supply (PSU ripple, loose fuse)
- watchdog reset inside node electronics
- short circuit on node I/O channel
Replacement parts
We supply the following units for this alarm — tested, warranty-backed:
- Request a quote →
node 24 V power wiring/connector per install manual
cable · Common cause
- Request a quote →
affected remote CAN node module (identify number via error window)
board · Common cause
Need the part urgently?
Send us alarm 6034 with your machine details — typical RFQ turnaround is 24–48h.