Siemens alarm 611U-F513: Measuring circuit error, direct measuring system absolute track
SIMODRIVE 611U drive alarm · SIMODRIVE 611D/611U
What it means
For EnDat absolute scales this reports an initialization error on the absolute track; reason details are held in P1033 (direct measuring system diagnostics). Typical root causes are cabling/type mismatches rather than dead electronics.
Likely causes
- wrong encoder cable type fitted
- incorrect encoder type configured (e.g. ERN incremental instead of EQN absolute)
- noise coupling due to inadequate screening
- sporadic contact interruptions; scale or control module defective
Triage note: Read P1033 bit coding (same structure as 611D MD 1033) to pinpoint amplitude/CRC/time-out causes.
Replacement parts
We supply the following units for this alarm — tested, warranty-backed:
- Request a quote →
original EnDat cable set
cable · Primary suspect
- Request a quote →
EQN/EnDat absolute scale
encoder · Common cause
- Request a quote →
6SN1118-…
control-board · Check if others ruled out
Need the part urgently?
Send us alarm 611U-F513 with your machine details — typical RFQ turnaround is 24–48h.